Point Cloud Loss
Symptom:
Point loss occurred in point cloud in real usage scenarios.
Affected Software Versions:
All Mech-Vision versions
Possible Cause:
-
There were point losses in the point cloud output by Mech-Eye Viewer.
-
There were point losses during the point cloud processing on Mech-Vision.
Solution:
Please fix the issue according to the point cloud processing procedure. The steps are as follows:
-
Check whether the point cloud output from Mech-Eye Viewer is up to standard.
-
If point clouds are lost, please refer to Troubleshooting to resolve the issue.
-
If no point cloud is lost, proceed to the next step.
-
-
Check the processing procedure on Mech-Vision.
-
Check whether the option Remove Background by Depth is enabled in the Capture Images from Camera Step.
-
If yes, you should switch on the Debug Output mode, execute the single Step, and check whether the point clouds needed are removed. If they are removed, you should perform Select background depth map file again or disable Remove Background by Depth.
-
If not, proceed to the next step.
-
-
Check 3D ROI.
-
Check point clouds with the Step “Show Point Clouds and Poses”.
-