Page Crash When Entering the “Set Motion Path” Process During Calibration

You are currently viewing the documentation for the latest version (2.1.2). To access a different version, click the "Switch version" button located in the upper-right corner of the page.

■ If you are not sure which version of the product you are currently using, please feel free to contact Mech-Mind Technical Support.

Symptom:

During the automatic hand-eye calibration, the page crashed when entering the “Set Motion Path” process.

Possible Cause:

The IPC or PC where the software is installed does not meet the recommended system requirements.

Solution:

Please refer to the System Requirements to upgrade your IPC or PC configuration.

Is this page helpful?

You can give a feedback in any of the following ways:

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept