No Vision Result When Mech-Viz Was Used to Master-Control the Robot

Symptom:

Mech-Vision had output the vision result, but the robot did not receive it.

Affected Software Versions:

All Mech-Viz versions

Possible Causes:

  • Auto-load is not set for the Mech-Vision project.

  • Auto-load is not set for the Mech-Viz project.

  • Steps “Visual Recognition” and “Vision Move” did not read the correct Mech-Vision project.

  • The communication component did not run.

  • External signals were abnormal.

Solution:

Follow these steps to fix the issue:

  1. Start Mech-Vision, right-click the solution to which the project belongs and select the Autoload Solution checkbox.

  2. Start Mech-Viz, right-click the project and select the Autoload Project checkbox.

  3. In Steps “Visual Recognition” and “Vision Move” of the Mech-Viz project, confirm that the Vision Name parameter has been set to the correct Mech-Vision project.

  4. Run the communication component.

  5. Check external signals.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.