Obtain Results

After a series of measurements are made on the section profiles of applied beads, you can set an acceptable range for the output item NG Count. Ideally, there should be no breakage or bead overflow, namely that the measured results of all section profiles should be up to standard, and the NG count should be 0.

After the setting is finished, you can run the Measure Surface Track Step and view the measurement and inspection results in the Output Results panel below the data visualization area.

The bead inspection result depends on the inspection result of section profiles, that is, the overall judgment result of the project. Click the Output Management button from the toolbar of the home interface to set quality judgment rules for the project.

Select the project under the Quality judgment tab, set the “Judgment type” to Comprehensive, and select the output item corresponding to the inspection result of section profiles.

Example:

Then, click the Apply button to save the settings. Run the project, and you will obtain the judgment result of the project in the upper-left corner of the graphical programming workspace.

If you need to send the measurement and inspection results to an external device, you can configure the settings under the Communication output tab in the “Output Management” window.

Now, you have finished the deployment of the offline bead inspection solution.