Obtain Results

Upon the process of Measure the Flatness of Battery Compartment’s Surface, you can select the Measure Surface Flatness Step and set an acceptable range for its output item Global Flatness.

After the Step is run, you can view the flatness measurement and inspection results in the Output Results panel.

Upon the process of Measure the Height of Locating Holes, you can select the Measure Dimensions by Features Step and set an acceptable range for its output item Distance.

After the Step is run, you can view the height measurement and inspection results in the Output Results panel.

The quality inspection result of the smartphone midplate should consider both the flatness of the battery compartment’s surface and the height of the locating hole, that is, the quality judgment result of the project. Click the Output Management button from the toolbar of the home interface to set quality judgment rules for the project.

Select the project under the Quality judgment tab, set the “Judgment type” to Comprehensive, and select the output items corresponding to the flatness and height measurement results.

Example:

Then, click the Apply button to save the settings. Run the project, and you will obtain the judgment result of the project in the upper-left corner of the graphical programming workspace.

If you need to send the measurement and inspection results to an external device, you can configure the settings under the Communication output tab in the “Output Management” window.

At this point, you have finished deploying the smartphone midplate flatness measurement solution.