Obtain Results
Obtain Inspection Result of Pin Height
After pin height measurement, the acceptable height range for pins can be determined based on actual requirements. Mech-MSR will evaluate the measured height against the set range to determine whether it is within the acceptable limits, and the height inspection result will be output accordingly.
The detailed instructions are as follows:
-
Click the Measure Dimensions by Features Step in the Measure Pin Height process.
-
In the Output section of the Step, expand Distance to set the acceptable height range of pins.
-
Run the Step, and you can check the inspection result of pin height in the Output Results panel at the bottom of the visualization area.
Measured values of pin height all fall within the acceptable range, and thus the inspection result of the output item is OK.
Obtain Inspection Result of Connectors
The inspection result of connectors depends on the pin height result, that is, the overall judgment result of the project. Click the Output Management button from the toolbar of the home interface to set quality judgment rules for the project.
Select the project under the Quality judgment tab, set the “Judgment type” to Comprehensive, and select the output item corresponding to the pin height measurement result.
Example:
Then, click the Apply button to save the settings. Run the project, and you will obtain the judgment result of the project in the upper-left corner of the graphical programming workspace.
|
(Optional) Send Measurement and Inspection Results to External Devices
If you need to send the measurement and inspection results to an external device, you can configure the settings under the Communication output tab in the “Output Management” window.
|
Select the item “Distance” corresponding to pin height, and set the data length to 8 (8 values for 8 pins). |
|
Up to now, you have finished the deployment of the pin height measurement solution.