I/O Control

You are currently viewing the documentation for the latest version (2.1.1). To access a different version, click the "Switch version" button located in the upper-right corner of the page.

■ If you are not sure which version of the product you are currently using, please feel free to contact Mech-Mind Technical Support.

External devices (such as PLCs) can connect to the I/O terminals on the controller of a laser profile, trigger the Mech-MSR projects to run through the general-purpose DI terminals, and obtain the overall quality judgment results of the Mech-MSR projects through the general-purpose DO terminals. In this setup, the Data Acquisition Trigger Source of the laser profiler is typically set to External.

  • Triggering a project to run (via general-purpose DI)

    If you need to trigger a Mech-MSR project to run via a DI terminal, first review the Input Signal Terminals of the controller (the LNX-7500 series is used as an example). Then refer to Configure Laser Profiler I/O Terminals to learn how to configure them in Mech-MSR.

  • Obtaining quality judgment result (via general-purpose DO)

    If you need to obtain the overall quality judgment result of a Mech-MSR project via a DO terminal, first review the Output Signal Terminals of the controller (the LNX-7500 series is used as an example). Then refer to Configure Laser Profiler I/O Terminals to learn how to configure them in Mech-MSR.

Is this page helpful?

You can give a feedback in any of the following ways:

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept