Extract Alignment Parameter Group

Description

Select the X, Y, or Z coordinates and the rotation angle about the Z-axis output by other Steps as the base point and reference orientation, respectively, to form an alignment parameter group.

Usage Workflow

  1. In the Input section, input the base point and reference orientation to be used.

  2. In the Output section, select Alignment Parameter Group.

  3. Run the Step and view output.

Input Description

Parameter Description

Base Point X/Y/Z

The X, Y, and Z coordinates of the base point, respectively.

Input the data as needed; there is no requirement to input all.

Reference Orientation

Rotation angle about the Z-axis.

  • If you need to use Base Point X, Base Point Y, and Reference Orientation, ensure that Base Point X and Base Point Y are output from the same Step.

Output Description

After the Step is run, it outputs an alignment parameter group formed on the basis of the input base point and reference orientation. The alignment parameter group can be input into other Steps to ensure the relative position of the set feature region in images remains consistent.

Troubleshooting

  • For common errors, see Error Code List.

  • If the error code is inconsistent with the error message, please contact Technical Support for help.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept