Run a Real Robot

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

Please follow these steps to run a real robot.

  1. Connect to the Robot Properly

    Before you use Mech-Viz to guide a real robot to move, please ensure that the communication between the robot and the software is established successfully, or else the robot cannot be moved by Mech-Viz.

  2. Stop the Simulation

    SelectMech-Center  Deployment Settings  Mech-Viz, and unselect Run as simulation.

  3. Reduce the Robot Speed

    Before you run a real robot, please ensure that you have lowered the robot speed to a proper value for safety concerns. Pay attention to avoid an accident.

    Adjust the Velocity and Acceleration in the Mech-Viz toolbar to 5%. icon

  4. Run the Robot

    Click Run in the Mech-Viz toolbar, or click Run in Mech-Center’s main interface and then the robot will follow the planned path to move.

    When an emergency occurs when the robot is moving, please press the emergency stop button on the robot teach pendant.

  5. Stop the Project

    Click Stop in the Mech-Viz toolbar to stop the project.

If an error occurs when running a real robot, you can locate the reason with the assistance of Plan History and Log. If no error occurs, you can configure the Computation Settings to increase the software execution speed.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept