Set DO

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

Function

Set the specified DO port signal of the robot.

Parameter Description

General Parameters of Non-Move Steps

Skip Execution

None

Default setting. Do not skip the current Step.

Simulation only

Skip the current Step during simulation. The exit port is specified by Out Port When Skip.

Always

Skip the current Step when the project is simulating or running. The exit port is specified by Out Port When Skip.

Instruction

When Simulation only or Always is selected, the current Step will be skipped and the subsequent Step will be executed when running the project. If this parameter is set to None in “Check DI” Step in the project, and there is no external input signal during simulation, the project will be stopped when executing to this Step. In this case, setting the parameter to Simulation only or Always enables the simulation to continue.

Out Port When Skip

This parameter will take effect when Skip Execution is set to Simulation only or Always. It specifies the exit port when skipping a Step.

Wait Move Precisely

Selected by default. In other words, the Step will execute only when the robot has moved to the specified position precisely.

Digital Out Value

Instruction: Set value of the digital output port according to actual wiring.

DO Port

Default value

0

Instruction

Input the DO Port corresponding to the actual I/O wiring of the robot.

Delay Time

The delay time for outputting the signal, 0 by default. Set the parameter according to your needs.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.