Adjust Poses by Offsets

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

Contents of this Step are under maintenance. If you need more information about this Step with urgency, please contact us at docs@mech-mind.net.

Function

This Step adjusts the pick points by calculating the pose offset between the cylinders’ poses and the correct tool center points (i.e., the pick points), and outputs the actual poses of the cylinders and the offsets from the poses to the correct pick points.

Usage Scenario

This Step is usually used for picking cylindrical bars that are closely attached to each other end-to-end, preventing two bars from being picked at the same time.

Input and Output

  • Input:

    1. Point clouds containing end-to-end attached cylindrical bars

    2. Robot tool center points that need to be corrected

    3. Length of a cylindrical bar

    4. Cylinder shape information

  • Output:

    1. Poses of cylindrical bars

    2. Offsets of correct pick points relative to calculated poses

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept