Configure Adapter Communication

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

This section introduces how to configure the Adapter communication. Before configuration, please confirm that you have already selected the robot and entered the Communication Option interface.

communication adapter

  1. On the Communication Option interface, set Interface Type to Adapter.

  2. Click communication icon 2 and select the folder of the Adapter project.

    You need to write the Adapter program first. For details, refer to Adapter Programming Guide.

  3. For the Host IP address, enter the IP address and port number.

    • The host IP address and the robot IP address must be on the same subnet.

    • The port number should be set to 50000 or larger.

  4. (Optional) Select Auto enable interface service when opening solution. When the solution is opened, you do not need to start the interface service manually.

  5. Click the Apply button.

  6. Start the interface service.

Next, you need to write the robot-side communication program by referring to Standard Interface Development Manual and load it to the robot.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept