Run Project and Debug

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

Starting from version 1.4.0, Mech-Vision will perform a version compatibility check when running a project. It is recommended to use Mech-Viz and Mech-Center of the same version as Mech-Vision.
If the version of Mech-Viz or Mech-Center used is lower than v1.4.0, a risk alert window will pop up when running a project.

Click Run in the toolbar or use the shortcut Ctrl + R to run the current Mech-Vision project, as shown below.

When the project’s running result does not meet expectations, the project needs to be debugged. First, it is necessary to locate the Step(s) of error by running the Steps one by one. The Step(s) whose result does not match expectations should be optimized by adjusting the Step parameters. For each executed Step, the execution time of the Step is displayed in the lower-left corner of the Step box, as shown below.

run project and debug project running time

For detailed instructions, please see Step Reference Guide.

Run Project and Debug

We Value Your Privacy