Run Project and Debug

You are currently viewing the documentation for version 1.7.4. To access documentation for other versions, click the "Switch Version" button located in the upper-right corner of the page.

■ To use the latest version, visit the Mech-Mind Download Center to download it.

■ If you're unsure about the version of the product you are using, please contact Mech-Mind Technical Support for assistance.

  • Starting from version 1.4.0, Mech-Vision will perform a version compatibility check when running a project. It is recommended to use Mech-Viz and Mech-Center of the same version as Mech-Vision.

  • If the version of Mech-Viz or Mech-Center used is lower than v1.4.0, a risk alert window will pop up when running a project.

Click Run in the toolbar or use the shortcut Ctrl + R to run the current Mech-Vision project, as shown below.

run project and debug run project now

When the project’s running result does not meet expectations, the project needs to be debugged. First, it is necessary to locate the Step(s) of error by running the Steps one by one. The Step(s) whose result does not match expectations should be optimized by adjusting the Step parameters. For each executed Step, the execution time of the Step is displayed in the lower-left corner of the Step box, as shown below.

run project and debug project running time

For detailed instructions, please see Step Reference Guide.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept