Configure Siemens PLC Snap 7 Communication

This section introduces how to configure the Siemens programmable logic controller (PLC) Snap 7 communication. Before configuration, please confirm that you have already selected the robot and entered the Communication Option interface.

communication snap7

  1. On the Communication Option interface, set the Set Interface Type parameter to Standard Interface, and set the Protocol parameter to Siemens PLC Client.

  2. In the IP Address region, set the parameters as follows.

    1. Specify the PLC IP Address parameter. The PLC IP address and the IPC IP address must be on the same subnet.

    2. Specify the Slot number parameter. Refer to the following table for instructions.

Siemens S7 Series Slot Number

S7-300

2

S7-1200

0 or 1

S7-1500

0 or 1

Other models

0

  1. Specify the DB number parameter.

    1. (Optional) Select Auto enable interface service when opening solution. When the solution is opened, you do not need to start the interface service manually.

    2. Click the Apply button.

    3. Start the interface service.

Next, you need to complete the remaining standard interface configuration according to the used PLC.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept