Update Pallet Pose

You are currently viewing the documentation for version 1.7.5. To access documentation for other versions, click the "Switch Version" button located in the upper-right corner of the page.

■ To use the latest version, visit the Mech-Mind Download Center to download it.

■ If you're unsure about the version of the product you are using, please contact Mech-Mind Technical Support for assistance.

Function

Update the pallet pose via the vision service.

Usage Scenario

After a palletizing task is completed, a new pallet will be in place, and the pallet pose should be updated. This Step updates the pallet pose in the specified palletizing Steps via the vision service.

Parameter Description

General Parameters of Non-Move Steps

Skip Execution

None	Default setting. Do not skip the current Step.
Simulation only	Skip the current Step during simulation. The exit port is specified by Out Port When Skip.
Always	Skip the current Step when the project is simulating or running. The exit port is specified by Out Port When Skip.
Instruction	When Simulation only or Always is selected, the current Step will be skipped and the subsequent Step will be executed when running the project. If this parameter is set to None in “Check DI” Step in the project, and there is no external input signal during simulation, the project will be stopped when executing to this Step. In this case, setting the parameter to Simulation only or Always enables the simulation to continue.

Out Port When Skip

This parameter will take effect when Skip Execution is set to Simulation only or Always. It specifies the exit port when skipping a Step.

Save Pallet Pose

Unselected by default, i.e., do not save the updated pallet pose. Select to save the updated pallet pose. You can click icon_path next to the File Path to Save Pallet Pose to specify a path to save the pallet pose file.

Load Pallet Pose

Unselected by default, i.e., do not load the pallet pose. Select to load the pallet pose. Click icon_path next to the File Path to Load Pallet Pose to select the pallet pose file to load.

Select Palletizing Step

Select the palletizing Step in which the pallet pose should be updated.

Vision Name

Select the registered vision service from which the new pallet pose will be obtained.

Usage Example

After the robot completes a palletizing task, a new pallet will be used, and then the pallet pose should be updated. This Step should be used in conjunction with Vision Look.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

I accept

I don't accept