Measure Height Differences Points to Baseline

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

This Step is used to calculate the height difference from points to the baseline.

Before using this Step, please refer to Getting Started with Measurement Mode to learn about basics of Measurement Mode.

Sample Application

measure height differences points to baseline application sample

Connect Read Point Cloud V2, Orthographic Projection, and Measure Height Differences Points to Baseline to calculate the height difference from points to the baseline.

Connect Steps

  1. Click Orthographic Projection, go to the Step Input Source Selection panel, and then select Read Point Cloud V2_1_Point Cloud With Normals as Input 1 (Point Cloud With Normals).

  2. Click Measure Height Differences Points to Baseline, go to the Step Input Source Selection panel, and then select Orthographic Projection_1_Depth Image as Input 1 (Visualization Background).

Configure parameters

  • Configure in Read Point Cloud V2 Click the Step and configure the Point Cloud Source and other parameters in the Step Parameters panel. Click Run to run the project after the settings.

  • Configure in Measure Height Differences Points to Baseline The baseline is located in the upper left corner in the sketchpad area by default, drag it onto the point cloud and adjust the length.

measure height differences points to baseline base line

You can also adjust the position of the baseline in the Step Parameters panel, as shown below.

measure height differences points to baseline base line move

Click the + button to add one or more detect points:

measure height differences points to baseline add point

Drag the newly added points from the upper left corner in the sketchpad area onto the point cloud:

measure height differences points to baseline move point

You can also adjust the position of the detect points in the Step Parameters panel, as shown below.

measure height differences points to baseline move point parameter

Read the result

Click the Step Measure Height Differences Points to Baseline and check the measurement result in the Measurement Output panel.

measure height differences points to baseline measure result

If multiple detect points have been added, there will be multiple measurement results.

The measurement result will be displayed in Measurement Output and Result View panels as well. You can also set the LSL (lower specification limit) and USL (upper specification limit) to check whether the measurement conforms to the specification.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept