Getting Started

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

Example Projects

A variety of built-in example projects are provided in Mech-Viz to help you get familiar with the software quickly. These projects cover common usage scenarios, and you can run the example projects to see the operation effect.

Taking Basic Pick and Place project under the category of Simple handling for example, this section will describe how to open and run the example project (The same operation method goes to other projects).

  1. Go to File>New>Example projects, click the Basic Pick and Place project card, and then click Choose Project in the project description panel to open the project.

  2. Click Simulate in the upper-left corner of the interface.

  3. Click Start simulation in the pop-up Select Vision Record to Use window.

  • Click the Pause button to pause simulation.

  • Click the Stop button to stop simulation.

  • To change the example project, select other example projects in the File>New>Example projects when the project in use stops.

  • To reduce the speed of robot, modify Vel. and Acc.on the toolbar when the project in use stops.

Create a Project

The process of building and configuring a Mech-Viz project usually consists of the following steps:

  1. Click File>New>New blank project.

  2. Select a robot model in the Robot Model Library.

  3. Configure the resources, including tool, workobject, scene, etc., in the project.

  4. Build a workflow, i.e. robot control logic.

  5. Simulate and improve the project.

getting project

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept