Error Occurred When Reference Direction and Fixed Axis Direction Set the Same in the Step “Rotate Axis to Minimize Included Angle to Reference Direction”

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

Symptom:

In the Step “Rotate Axis to Minimize Included Angle to Reference Direction”, when the reference direction and the fixed axis direction were set the same, the following error message appeared: [error] Illegal parameter!.

Affected Software Versions:

All versions

Possible Cause:

The Step “Rotate Axis to Minimize Included Angle to Reference Direction” does not support reference direction and fixed axis direction being set the same.

Solution:

If the reference direction needs to be set the same as the fixed axis direction when you adjust the pose, please use Step “Rotate Poses to Directions Freely” instead.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.