Could not Find Old Steps after Software Upgrade

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

Symptom:

Could not find the Steps used in an old version after Mech-Vision was upgraded.

Affected Versions:

All versions.

Possible Causes:

  1. Some Steps are deleted or merge into other Steps after the software update.

  2. Some Steps that are infrequently used are not checked in the “About Plugins” window.

Solution:

Go to the menu bar of Mech-Vision > Help > About Plugins, find and check the corresponding Steps, then click finish.

If you cannot find the old Steps, it means they have been deleted in the current version. In this case, you need to replace them with other Steps.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.