Reset
Usage Scenario
This Step is usually used to reset the parameters of the Counter Step, the Reuse Vision Result parameter, etc.
Instructions
The usage of the Reset Step is as follows:
-
Connect “Reset” Step at the workflow node where the reset operation is required.
-
In this Step parameter panel, click Configure to open the “Reset Step Parameters” configuration window.
In the current project, Steps that can be reset are displayed in groups in the Step list on the left. Once the Step group is unfolded, click the specific Step, and the parameters of the selected Step that can be reset will be displayed in the parameter list on the right. -
Select the Step(s) and parameter(s) that need to be reset.
-
Click Confirm.
When the project executes to this Step, the status of the selected Steps and their parameters will be reset.