DLL load failed: The specified procedure could not be found

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

Symptom:

When starting the communication component by executing the command.\python\python.exe .\src\main.py in the installation directory of the communication component via powershell or cmd, Python reports the error “DLL load failed: The specified procedure could not be found”.

Affected Software Versions:

All versions

Possible Cause:

The corresponding Python libraries were not installed.

Solution:

  1. Uninstall Mech-Vision & Mech-Viz and reinstall them.

  2. Download the repair software DirectX Repair to fix the plugins.

  3. Check the system environment variables, and if there are variables like PYTHONHOME or PYTHONPATH, try removing them. (ensure that deleting these Python environment variables will not affect other software).

  4. If the issue persists after performing the above steps, please contact Mech-Mind Technical Support.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept