Create and Save Project

This section provides information on creating a new Mech-Vision project, saving the project, and the naming convention of project names.

Create New Projects

There are three ways to create a new project:

  • After creating a new solution, create a new blank project in it.

  • Select File  New Project in the menu bar to create a new blank project.

  • Press Ctrl + N on the keyboard to create a new blank project.

You can only create a new project after creating a new solution.

Save Projects

You can save a single project in a solution or save all projects in the solution.

Save a Single Project

There are two ways to save a single project in a solution:

  • Select File  Save Project in the menu bar to save a single project.

  • Click create and save project icon on the left end of the project toolbar or press Ctrl + S on the keyboard to save a single project.

create and save project

Save all Projects in the Solution

If you want to save all projects in a solution, select File  Save Solution in the menu bar to save all projects in the solution.

Naming Convention of Project Names

The recommended naming convention of Mech-Vision projects is as shown below.

Components in the name Description

Vis

To distinguish Mech-Vision projects from Mech-Viz projects (compulsory)

Object Name + Application Scenario

For example: CartonDepalletizing/DiscBrakeMachineTending/ElectricMotorAssembly/SpongeGluing/ParcelPicking

No. or the position of the Camera

Camera No.: 1#CrackDetection1#HeatTreating1#
Camera Position: LeftCamera (optional)

Specific or special function

Specific function: Category1WorkpieceRecognition/ReflectiveWorkpieceRecognition/BinDetection/ModelMaking
Special function: PointCloudStitching/ImageStitchingFromTwoCameras (optional)

The table below provides some example names.

Scenario Example Name

Single Robot Cell + Single Camera

Vis-CartonDepalletizing

Vis-DiscBrakeMachineTending

Vis-ElectricMotorAssembly

Vis-SpongeGluing

Vis-ParcelPicking

Single Robot Cell + Multiple Cameras

Vis-WorkpieceMachineTending-LeftCamera

Multiple Robot Cells + Multiple Cameras

Vis-CrankshaftMachineTending-CrackDetection1#LeftCamera

Multiple Robot Cells + Multiple Cameras + Function

Vis-CrankshaftMachineTending-CrackDetection1#LeftCamera-PointCloudStitching

One camera in the robot cell is used to enable multiple functions

Vis-RzeppaJointMachineTending-5#LeftCamera-Category1WorkpieceRecognition

Vis-RzeppaJointMachineTending-5#LeftCamera-Category2WorkpieceRecognition

Vis-RzeppaJointMachineTending-5#LeftCamera-BinDetection

Vis-RzeppaJointMachineTending-5#LeftCamera-ModelMaking

Vis-RzeppaJointMachineTending-5#RightCamera-Category1WorkpieceRecognition

Vis-RzeppaJointMachineTending-5#RightCamera-Category2WorkpieceRecognition

When using English for naming, note that:

  • Use abbreviations instead of full names if possible.

  • Try not to use pinyin spelling.

  • Use camel case in word combinations.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.