Inconsistency between Poses of Real and Simulated Robots

You are currently viewing the documentation for version 2.0.0. To access documentation for other versions, click the "Switch Version" button located in the upper-right corner of the page.

■ To use the latest version, visit the Mech-Mind Download Center to download it.

■ If you're unsure about the version of the product you are using, please contact Mech-Mind Technical Support for assistance.

Symptom:

After importing a new robot model, the robot pose or tool pose of the simulated robot in the software and that of the real robot are not consistent.

Possible causes:

The robot model configurations or parameters are wrong.

Solution:

Please refer to Guide for Robot Model Parameter Verification to complete the verification of the parameters of the robot model. After verification, please confirm whether the issue still exists.

  • If not present, the troubleshooting is completed.

  • If still present, please contact Technical Support.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.