Step “Capture Images from Camera” Could Not Load Calibration Parameter Group
Symptom:
When the “Capture Images from Camera” Step was used, the setting of the calibration parameter group failed, and the Step could not load the calibration parameter group.
Affected Versions:
All Mech-Vision versions.
Possible causes:
-
The network connection is abnormal.
-
There is no calibration parameter group in “Project folder/calibration”.
Solution:
-
Check and ensure that the network connection is functioning properly.
-
Check and make sure that the calibration parameter group is saved in “Project folder/calibration.”
-
Restart the software or camera.
-
If the issue persists, please contact Technical Support.