FAQs
This document provides solutions to frequently asked questions about the software.
|
If you encounter an issue not covered in this document, please visit the Mech-Mind online community (you need to register and log in) for more information. |
Issue 1: What Is the Relationship Between Mech-Metrics, Mech-MSR, and the Robot?
Q: What is the relationship between Mech-Metrics, Mech-MSR, and the robot?
A: Connection among the three:
-
The robot establishes a connection with Mech-MSR.
-
Mech-MSR establishes a connection with Mech-Metrics.
Usage process of the three:
-
The robot runs the measurement program, which triggers Mech-Metrics to operate.
-
Mech-Metrics uses Mech-MSR for measurement.
-
Mech-MSR returns the measurement data to Mech-Metrics.
-
Mech-Metrics sends the measurement result (OK or NG) back to the robot.
Issue 2: Does One Mech-Metrics Project Correspond to One Mech-MSR Solution?
Q: Does one Mech-Metrics project correspond to one Mech-MSR solution?
A: No. A Mech-Metrics part corresponds to a Mech-MSR solution. The correspondence between Mech-Metrics resources and Mech-MSR resources is shown in the figure below:
Issue 3: Does Mech-Metrics Support Using Multiple Robots for Measurement Simultaneously?
Q: Does Mech-Metrics support using multiple robots for measurement simultaneously?
A: Yes, Mech-Metrics supports simultaneous measurement with multiple robots. For example, two robots can measure opposite sides of a part simultaneously to improve efficiency.