KUKA Error Messages
The following errors may occur while running the Standard Interface program on the robot.
Socket Connection Timeout
“ROBOT_SOCKET_TIMEOUT”
-
Description: MM_Flag_Recv is called to check data reception. This error is reported if no data are received within the specified wait time.
-
Troubleshooting:
-
Check if the order of calling EKI_Send and MM_Flag_Recv is correct.
-
Check if the Standard Interface service (TCP HEX) is started in Mech-Vision.
-
Check if the wait time input through the MM_Flag_Recv command is too short.
-
Communication Connection Error
“ROBOT_SOCKET_CLOSED”
-
Description: MM_Flag_Alive detects that communication can not be established within the specified wait time.
-
Troubleshooting:
-
Check if the hardware is properly connected.
-
Check if the Standard Interface service (TCP HEX) is started in Mech-Vision.
-
Check the IP addresses of the robot and the IPC, and if the port number is configured correctly.
-
Check if the firewall is turned off on the IPC.
-
Please contact Mech-Mind Technical Support for further assistance.
-
Procedure Argument Error
“ROBOT ARGUMENT ERROR”
-
Description: When calling a Standard Interface procedure, arguments provided are not correct.
-
Troubleshooting: Please refer to KUKA Standard Interface Commands and input the correct arguments accordingly.
Invalid Interface Command
“ROBOT_CMD_ERROR”
-
Description: The command code returned to the robot does not match the one sent to Mech-Vision.
-
Troubleshooting: The sequence of command sending and receiving is problematic. Please contact Mech-Mind Technical Support for further assistance.
Status Code Error
10XX / 20XX /30XX /40XX /50XX /70XX /90XX
-
Description: An invalid status code is in the received data for the interface command called by the program. Please check the log messages in the Console tab of Mech-Vision Log panel.
-
Troubleshooting:
-
Please refer to the Status Codes and Troubleshooting for the specific error.
-
Contact Mech-Mind Technical Support for further assistance.
-