AUBO

This guide shows you how to set up Master-Control communication with an AUBO robot.

Check Controller Compatibility

The version of the controller should be above 4.5.44. If the version is lower, please contact AUBO after-sales support for a system version upgrade.

Go to About  Version, check the version of the controller in Server Version.

Set up the Network Connection

Connect the Hardware

Plug the Ethernet cable into the Ethernet interface of the controller to connect the IPC and the robot controller.

control cabinet

Set the IP Address

Press on Settings  System  Network to configure the Interfaces, Netmask, IP Address, and Gateway. Please note that the robot IP should be in the same subnet as the IPC. Then select Save and restart the robot.

set ip

Test Robot Connection

Please refer to Test Robot Connection.

Troubleshooting

If the robot cannot be connected successfully, and the error is DLL load failed: %1 is not a valid Win32 application , please check whether the C runtime library on your computer is complete. The complete C runtime library is shown below.

full cpp

If the library is not complete, please download the vc runtime library repair DirectX Repair V3.9 to fix the error.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept