Check Tool

Function

This Step is used in scenarios where multiple robot tools are used. It is used to check if the current tool is the same as the selected tool. If the same, it will proceed along the first exit port, without executing the Steps for switching tools. If not the same, it will proceed along the second exit port and execute the Steps for switching tools.

Parameter Description

General Parameters of Non-Move Steps

Skip Execution
None

Default setting. Do not skip the current Step.

Simulation only

Skip the current Step during simulation. The exit port is specified by Out Port When Skip.

Always

Skip the current Step when the project is simulating or running. The exit port is specified by Out Port When Skip.

Instruction

When Simulation only or Always is selected, the current Step will be skipped and the subsequent Step will be executed when running the project. If this parameter is set to None in “Check DI” Step in the project, and there is no external input signal during simulation, the project will be stopped when executing to this Step. In this case, setting the parameter to Simulation only or Always enables the simulation to continue.

Out Port When Skip

This parameter will take effect when Skip Execution is set to Simulation only or Always. It specifies the exit port when skipping a Step.

Set tool as...

Select the model of the expected robot tool to check if the current tool is right.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.