Calc Flatness Error

This Step is used to calculate the flatness error of the planar point cloud.

  • Degree of flatness is a critical indicator to maintain quality control throughout the manufacturing process. The surfaces of products are usually required to achieve a desired degree of flatness.

  • Flatness error describes the deviation of a measured plane surface from the theoretical plane surface which has the desired degree of flatness.

Before using this Step, please refer to Getting Started with Measurement Mode to learn about basics of Measurement Mode.

Sample Application

calc flatness error application sample

Connect Steps

Click Calc Flatness Error, go to the Step Input Source Selection panel, and then select Read Point Cloud V2_1_Point Cloud With Normals as Input 1 (Planar Point Cloud).

Configure parameters

Configure in Read Point Cloud V2

Click the Step and configure the Point Cloud Source and other parameters in the Step Parameters panel. After configuration, click Run to run the project.

The point cloud used in this sample application is shown below.

calc flatness error point cloud sample

Read the result

After running the project, click Calc Flatness Error and check the flatness error in the Measurement Output panel.

calc flatness error measure result

You can set the LSL (lower specification limit) and USL (upper specification limit) in Measurement Output and Result View panels to check whether the measurement conforms to the specification.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept