Set Holding State

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

Function

This Step is used to set the holding state. It is generally used for updating the holding state after the robot task has failed.

Usage Scenario

This Step is used in conjunction with the Pick or Place parameter of move-type steps to update the holding state.

Parameter Description

General Parameters of Non-Move Steps

Skip Execution

None	Default setting. Do not skip the current Step.
Simulation only	Skip the current Step during simulation. The exit port is specified by Out Port When Skip.
Always	Skip the current Step when the project is simulating or running. The exit port is specified by Out Port When Skip.
Instruction	When Simulation only or Always is selected, the current Step will be skipped and the subsequent Step will be executed when running the project. If this parameter is set to None in “Check DI” Step in the project, and there is no external input signal during simulation, the project will be stopped when executing to this Step. In this case, setting the parameter to Simulation only or Always enables the simulation to continue.

Out Port When Skip

This parameter will take effect when Skip Execution is set to Simulation only or Always. It specifies the exit port when skipping a Step.

Pick State

Select Hold or None according to the actual workflow of the project.