Set Robotiq

You are currently viewing the documentation for version 1.8.3. To access documentation for other versions, click the "Switch Version" button located in the upper-right corner of the page.

■ To use the latest version, visit the Mech-Mind Download Center to download it.

■ If you're unsure about the version of the product you are using, please contact Mech-Mind Technical Support for assistance.

  • This Step is available only when the Developer Mode is enabled.

  • Contents of this Step are under maintenance. If you need more information about this Step urgently, please visit Mech-Mind Online Community.

Function

This Step enables the RobotIQ gripper to be controlled directly through Mech-Viz. The serial communication is established to control the RobotIQ gripper. PC or IPC can control its position/speed/force through 485 serial port (or USB to 485).

Is this page helpful?

You can give a feedback in any of the following ways:

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept