Measurement Mode

You are currently viewing the documentation for the latest version (2.1.2). To access a different version, click the "Switch version" button located in the upper-right corner of the page.

■ If you are not sure which version of the product you are currently using, please feel free to contact Mech-Mind Technical Support.

Click the measure icon in the 3D simulation area to enable the measurement mode, so as to verify the model dimensions or placement locations of imported objects, making the layout in 3D simulation area more closely align with the on-site situations.

Icon Description

measure distance icon

Measure the line distance between two points. Hold the Shift key and left-click to select two points.

measure angle icon

Measure the angle between two edges. Hold the Shift key and left-click to select three points.

measure circle icon

Measure the diameter of a circle. Hold the Shift key and left-click to select any three points on the circle to calculate its diameter.

keep all icon

Keep all measurement results. When disabled, only the most recent measurement result will be kept. When enabled, all measurement results will be kept.

Is this page helpful?

You can give a feedback in any of the following ways:

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.