When Running the Main Control Program on the FANUC Robot, the System Reported a Task Execution Failure (SYST-011) and Indicated That the UOP Was Acting as the Master Control Device (SYST-005)

You are currently viewing the documentation for a pre-release version (2.2.0). To access documentation for other versions, click the "Switch Version" button located in the upper-right corner of the page.

■ If you're unsure about the version of the product you are using, please contact Mech-Mind Technical Support for assistance.

Problem

When running the main control program on the FANUC robot, the system reported a task execution failure (SYST-011) and indicated that the UOP was acting as the master control device (SYST-005).

Possible Causes

This error will be triggered if the start button on the robot controller is used to start the robot while it is in remote mode.

Solutions

Set Remote/Local setup to Local. Then, restart the robot by using the start button on the controller.

faq1 1

Is this page helpful?

You can give a feedback in any of the following ways:

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept