Image Acquisition Effect Does Not Change After Adjusting Parameters

You are currently viewing the documentation for the latest version (1.0.0). To access a different version, click the "Switch version" button located in the upper-right corner of the page.

■ If you are not sure which version of the product you are currently using, please feel free to contact Mech-Mind Technical Support.

Symptom

After adjusting image acquisition parameters in the 2D Camera Management tool, image acquisition effect in the solution does not change.

Possible Causes

When a project runs, camera parameters configured in the "2D Smart Camera" Step take effect.

Solution

Adjust camera parameters in the "2D Smart Camera" Step, then run the project again.

Is this page helpful?

You can give a feedback in any of the following ways:

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept