The Robot Has Not Performed the Picking Task

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

This section introduces issues related to the robot not performing the picking task and provides solutions.

Possible Causes:

If issues related to the robot not performing the picking task occur, possible causes include:

  • The robot/PLC has failed to connect to the Vision System (IPC).

  • The robot/PLC has not received the vision results.

  • There is an alarm on the robot side.

Solutions:

  1. First, check for connection issues between the robot/PLC and the Vision System (IPC). Please refer to Troubleshoot Standard Interface Communication Connection Failure.

  2. If the communication connection is normal, then please check whether the Vision System sends the vision results. Please refer to The Vision System Has Not Output Any Results.

  3. If there are no issues with the above steps, check whether there is an alarm on the robot side. Please clear the alarm on the robot side and try again.

  4. If the issue still exists, please contact Technical Support.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept