Common Errors and Solutions
The following are common error messages that may occur when using a Step. Check the possible causes and solutions for the errors.
|
If the issue cannot be resolved, try the following:
|
Error: invalid input
| No. | Possible Cause | Solution |
|---|---|---|
1 |
The input profile, depth map, or intensity image is empty. |
Ensure that the Step input is not empty. |
2 |
The dimensions of the depth map and intensity image input to the Step do not match. |
Ensure that the dimensions of the depth map and intensity image input to the Step are consistent. |
3 |
The input depth map is empty. |
Ensure that the depth map input to the Step is not empty. |
4 |
The input intensity image is empty. |
Ensure that the intensity image input to the Step is not empty. |
5 |
Not enough points have been input. |
Check the input data and make sure there are enough points. |
6 |
The input feature point is invalid. |
Ensure that the input feature point is valid. |
7 |
The input reference line is invalid. |
Ensure that a valid reference line is input. |
8 |
The input reference plane is invalid. |
Ensure that a valid reference plane is input. |
Error: invalid ROI
| No. | Possible Cause | Solution |
|---|---|---|
1 |
The position, size, or orientation of the feature region is invalid. |
Reset the feature region and make sure it is valid. |
2 |
Not enough points are defined in the feature region. |
Adjust the feature region to ensure that it has enough points. |
3 |
The set feature regions are empty. |
Ensure that there is at least one feature region that is not empty. |