GenICam Quick Facts

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

Mech-Eye Industrial 3D Camera (“camera”) supports the GenICam standard, which allows GenICam-compliant third-party machine vision software (“GenICam clients”) to control them.

After upgrading the camera firmware to 2.0.0 or above, you can directly control the camera with GenICam clients (such as HALCON) without any extra procedures.

Basic knowledge on GenICam:

GenICam Basics

Instructions on using HALCON to control the camera:

HALCON: Connect to Camera, Perform Image Capturing, and Adjust Parameters
HALCON: Hand-Eye Calibration
HALCON: Obtain Textured Point Cloud
HALCON: Obtain Depth Values Only
HALCON: Set IP Address

Useful reference information for using GenICam:

Camera Parameters Supported for GenICam
Use Mech-Eye Viewer to Adjust Camera Parameters for GenICam Client
Obtain HALCON-Readable Point Cloud through Mech-Eye API

GenICam Quick Facts

We Value Your Privacy