ABB Error Messages
The following errors may occur while running the Standard Interface program on the robot.
Socket Connection Timeout
“MM:Robot Error”,”Socket Timeout,Check connection”
-
Cause: The robot program didn’t receive data within the specified wait time when calling the instruction SocketReceive.
-
Troubleshooting:
-
Check if the sequence of calling SocketSend and SocketReceive is correct.
-
Check if the Standard Interface service is started in Mech-Vision.
-
Check if the arguments of SocketReceive are set correctly.
-
Communication Connection Error
“MM:Robot Error”,”Socket Closed,Check connection”
-
Cause: The robot couldn’t establish communication with Software Suite.
-
Troubleshooting:
-
Check if the hardware is properly connected.
-
Check if the Standard Interface service (TCP HEX) is started in Mech-Vision.
-
Check the IP addresses of the robot and the IPC, and if the port number is configured correctly.
-
Check if the firewall is turned off on the IPC.
-
Please contact Mech-Mind Technical Support for further assistance.
-
Procedure Argument Error
“MM:Robot Error”,”Wrong Arguments”
-
Cause: When calling a Standard Interface procedure, arguments provided are not correct.
-
Troubleshooting: Please refer to ABB Standard Interface Functions and input the correct arguments accordingly.
Invalid Interface Command
“MM:Robot Error”, “CMD No. Error”
-
Cause: The command code returned to the robot does not match the one sent to Mech-Vision.
-
Troubleshooting: The sequence of command sending and receiving is problematic. Please contact Mech-Mind Technical Support for further assistance.
Status Code Error
“MM:IPC Error”, “Check IPC status”
-
Description: Returned status code is an error code. Please check the log messages in the Console tab of Mech-Vision Log panel.
-
Troubleshooting:
-
Please refer to the Status Codes and Troubleshooting for the specific error.
-
If needed, please contact Mech-Mind Technical Support.
-