Warm-Up Tool
This tool is used to warm up the camera. If the camera has not been used to acquire data for more than 30 minutes, you should warm up the camera before acquiring data to ensure data accuracy.
Follow these steps to perform camera warm-up:
-
Connect to the camera.
-
Click Tools in the menu bar and select Warm-Up Tool.
-
In the sidebar on the right side of the Warm-Up Tool window, set the following parameters.
These parameters take effect only during the warm-up process. Adjusting the parameters does not affect the parameter settings in the main interface.
-
Warm-up time: Sets the total duration of the warm-up process.
-
Value range: 15-90 min
-
Default value (recommended):
LSR S-GL and UHP-140-GL
60 min
Other models
30 min
-
-
Data acquisition interval: Sets the interval of triggering data acquisition. If a trigger signal is received during an ongoing round of data acquisition, it will be ignored by the device.
Warm up the device with the data acquisition interval in actual use. If the data acquisition interval in actual use is not fixed, it is recommended to warm up with the average data acquisition interval. For example, in actual use, data is acquired every 6 to 10 seconds, then during warm-up, data should be acquired every 8 seconds.
Value range
Default value
UHP-140-GL
3-30 s
3 s
Other models
3-30 s
5 s
-
-
Click the Start warming up button to start warming up the camera.
Click the Stop warming up button to stop warming up the camera. Click the Start warming up button again to restart the warm-up time.