Picking Pose Planned Was Not Within the Vision Results Output by Mech-Vision

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

Symptom:

The picking pose planned by Mech-Viz was not within the vision results output by Mech-Vision.

Affected Software Versions:

All versions.

Possible Cause:

The “Reuse Vision Result” parameter is checked in the “Vision Move” Step. Therefore, the vision result that leads to a planning failure and the rest unused vision results will be retained and used for the next planning.

Solution:

In the scenario of capturing an image and then picking a workobject, after the planning of the "Vision Move" Step succeeds or fails, you need to use the "Reset" Step to reset the status of the "Vision Move" Step.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.