What’s New in the User Manual

July 1, 2022

• New Added Prerequisites for Mech-Mind Software and chapters in Support regarding software license and Python version

June 24, 2022

• [Mech-Vision] New Added Measurement Mode Guide and updated chapters on the relevant Steps.

• [Robot Integrations] New Added setup instructions for PROFINET and EtherNet/IP in Standard Interface

June 10, 2022

• [Mech-Interface] New Added Development Manual for Mech-Interface’s Standard Interface

• [Robot Integrations] New Added Robot Integrations, including instructions on setting up full-control and Mech-Interface’s Standard Interface

May 12, 2022

• [Mech-Vision v1.5.2] Improve Added solutions to problems related to deep learning model in Typical Applications

• [Mech-Center v1.5.2] Improve Restructured the content of Mech-Center User Manual

May 7, 2022

• [Mech-Vision v1.5.1] Improve Updated chapters on the 120 most frequently used Steps

April 15, 2022

• [Mech-Vision v1.5.1] Improve Updated some figures and the following chapters in Mech-Vision to match the software version 1.5.1:

  • Getting Started with Mech-Vision

  • Run Steps and View Outputs

  • Introduction to Step Comments

• [Mech-Vision v1.5.1] Improve Updated chapters on the 60 most frequently used Steps