Error Occurred When Reference Direction and Fixed Axis Direction Set the Same in Step “Rotate Axis to Minimize Included Angle to Reference Direction”

Symptom:

In Step Rotate Axis to Minimize Included Angle to Reference Direction, when the reference direction and the fixed axis direction were set the same, the following error message appeared: [error] Illegal parameter!

Affected Software Version:

All Mech-Vision versions

Possible Cause:

Step Rotate Axis to Minimize Included Angle to Reference Direction does not support reference direction and fixed axis direction being set the same.

Solution:

If the reference direction needs to be set the same as the fixed axis direction when you adjust the pose, please use Step Rotate Poses to Directions Freely instead.