Connect Camera and Industrial PC

Connect Directly

  • Ethernet Cable: insert one end into the port on the IPC and the other into the LAN port on the camera.

  • Power Adapter: insert the connector into the DC 24V port and the plug into a power supply, as shown below.

../../_images/connect_camera_and_ipc.png

When inserting the ethernet cable and power cable:

① Make sure the bump on the connector is aligned with the notch of the port.
② Tighten the nut after inserting the cable.

Attention

  • If multiple cameras or IPCs need to be connected, a network switch can be used.

  • The PWR indicator light should turn on after the cables are connected. If the light is not on, please contact technical support.

  • The recommended tightening torque for the bolts is 16 N·m.

  • The DIN rail or the DIN rail power supply should be reliably grounded. If using multiple DIN rail power supplies, ensure enough distance in between when mounting.

  • DIN Rail Power Supply

../../_images/din_rail_power_supply_connection.png

When wiring the DIN rail power supply, wires of the power cable must be inserted to the corresponding input/output terminal block connectors, as shown above.

The AC power cable has three wires: L, N, and PE (icon_pe).
The 24 V DC power cable has three wires: V+, V- and PE (icon_pe).

Hint

Please attach the plastic cover once you finish wiring to ensure the wires are isolated from each other.

Connect through a Network Switch

  • If multiple cameras or IPCs need to be connected, a network switch can be used, as shown below.

    ../../_images/switch_connection.png