Check DI

Note

Contents of this Step are under maintenance. If you need more information about this Step with urgency, please contact us at docs@mech-mind.net.

Description

Detect the signal value of the specified DI port of the robot. There are two output ports, if the value is 0, this task will output from left port, otherwise from right port.

Parameters

Basic Non-Move

See General Parameters of Non-Move Steps

DI Port

DI port of the robot to be checked

Pre Plan Out Port

Pre-planned output port

Setting basis: the default value is -1. If the value is -1, the plan will be interrupted, that is, two relative tasks before and after this task cannot be planed together

If the plan shall not be interrupted, write 0 when the task output from left port in most cases, otherwise write 1.