Certifications

Mech-Eye Industrial 3D Camera is compliant with the following standards and assessment requirements. Please note that the certification statuses may be updated. For more information, please contact the local sales agents.

  • European Electromagnetic Compatibility Standards.

  • U.S. ANSI C63.4 and 47 CFR PART 15B.

  • Canada ICES-003.

  • Japan VCCI-CISPR 32: 2016.

Safety of Laser Products

The Laser classification is implemented based on IEC 60825-1 in accordance with the requirements of Laser Notice No. 56 of the FDA (CDRH).

Model

Wavelength

IEC60825-1

Maximum output power

Laser class

LSR L

638 nm

2.46 mW

Class 2

Warning Label

../../../_images/laser_label.png

Warning Label Attachment

../../../_images/camera_laser1.png

Conformitè Europëenne (CE) Certifications

../../../_images/ce_logo.png

Hereby [Mech-Mind Robotics Technologies Ltd.] declares that [LSR L, PRO S, PRO M and UHP-140] is in compliance with the Electromagnetic Compatibility Directive 2014/30/EU.

The full text of the EU Declaration of Conformity is available here.

European Electromagnetic Compatibility Standards

  • EN 55032: 2015 + A1: 2020

  • EN IEC 61000-3-2: 2019 + A1: 2021

  • EN 61000-3-3: 2013 + A1: 2019 + A2: 2021

  • EN 55035: 2017 + A11: 2020

Important WEEE Information

../../../_images/recycle_logo.png

All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. Please contact the local authorities for more information about the location as well as terms and conditions of such collection points.

Federal Communications Commission (FCC) Certifications

../../../_images/fcc_logo.png

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.

“Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.”

Voluntary Control Council for Interference by Information Technology Equipment (VCCI) Certifications

../../../_images/vcci_logo.png

This is a Class A equipment. Operation of this equipment in a residential environment could cause radio interference. In such a case, the user may be required to take corrective actions.

UK Conformity Assessed (UKCA) Certification

../../../_images/ukca_logo.png